Sounds like you need the TPS HARD Reset, same symptoms as mine.
Follow the 'How To' Guide.
| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| ulysses rough with after market can https://www.ukbeg.com/forum/viewtopic.php?f=8&t=591 |
Page 1 of 1 |
| Author: | madbusabusa [ 24 May 2009 18:27 ] |
| Post subject: | ulysses rough with after market can |
hi, I've never joined a forum before, so beare with me! I have an 05 uly, that I have just fitted a jardine can and Remus Powerizer Fuel Injection Controller. The bike runs and isn't too bad under acceleration (ok-ish), but it's awful at low revs and in traffic. The closest I can say is like its running on one cylinder or running out of fuel- it's that kinda sensation. I'm not technical at all and a bit thick- does it sound like the sort of thing a dyno would sort, or is that a waste of cash? |
|
| Author: | pash [ 24 May 2009 18:34 ] |
| Post subject: | Re: ulysses rough with after market can |
How does it behave without the Powerizer? Sounds like a TPS reset may help - Check the How To section of the forum. |
|
| Author: | madbusabusa [ 24 May 2009 18:39 ] |
| Post subject: | Re: ulysses rough with after market can |
erm, I don't know cos I fitted them at the same time - oops! whats a tps rest? |
|
| Author: | pash [ 24 May 2009 18:42 ] |
| Post subject: | Re: ulysses rough with after market can |
Read the How To... Also, twould help if people knew where you were, there are plenty of people that wouldn't mind helping you... |
|
| Author: | madbusabusa [ 24 May 2009 18:47 ] |
| Post subject: | Re: ulysses rough with after market can |
oh, ok, I'm in chesterfield, derbyshire, thanks |
|
| Author: | Lands End [ 24 May 2009 21:24 ] |
| Post subject: | Re: ulysses rough with after market can |
Sounds like you need the TPS HARD Reset, same symptoms as mine. Follow the 'How To' Guide.
|
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|