UK Buell Enthusiasts Group
https://www.ukbeg.com/forum/

X1 Mainshaft trapdoor bearing
https://www.ukbeg.com/forum/viewtopic.php?f=8&t=4852		 Page 1 of 1
Author:  Martinwill [ 08 Feb 2010 11:02 ]
Post subject:  X1 Mainshaft trapdoor bearing
Having replaced the clutch basket bearing and sprocket/5th gear bearing i have noticed a small amount of play in the mainshaft roller bearing in the trapdoor.
In the workshop manual its a transmission strip down to press the shaft out, is it possible to replace the bearing without removing all gears/counter shaft etc ?
also could someone give me the bearing number (please :maz: !)
Author:  Maz [ 08 Feb 2010 12:28 ]
Post subject:  Re: X1 Mainshaft trapdoor bearing
Mainshaft is 6305 and before you ask the countershaft is 6204......both should be C3 but standard will be OK IMO. (they're ball races not rollers )

Tranny will need stripping but it's dead easy.......dont forget you'll also need 7 new snap rings :idea:
Author:  Martinwill [ 08 Feb 2010 18:40 ]
Post subject:  Re: X1 Mainshaft trapdoor bearing
More parts to get, the amount of play is tiny but i might as well do them, saves problems in the near future and taking it all apart again .
I'll get there in the end.
tis a shame you dont do mail order and it costs me 30 quid in fuel to visit, have you a part number for the snap rings please ? , i will have to get em online somewhere.
Many thanks Maz your help is appreciated,
Author:  Maz [ 09 Feb 2010 10:49 ]
Post subject:  Re: X1 Mainshaft trapdoor bearing
11067
Author:  pash [ 09 Feb 2010 13:54 ]
Post subject:  Re: X1 Mainshaft trapdoor bearing
:D
Author:  Martinwill [ 09 Feb 2010 14:50 ]
Post subject:  Re: X1 Mainshaft trapdoor bearing
Many thanks gents :yup:
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/