| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| X1 rear MC banjo brake switch https://www.ukbeg.com/forum/viewtopic.php?f=8&t=2375 |
Page 1 of 1 |
| Author: | Johnny Ableto [ 31 Aug 2009 10:36 ] |
| Post subject: | X1 rear MC banjo brake switch |
Want to fit brake switch banjo bolt to rear master cylinder of 2001 X1. What am I looking for, 3/8 UNF? or what? Thanks, John. |
|
| Author: | pash [ 31 Aug 2009 11:06 ] |
| Post subject: | Re: X1 rear MC banjo brake switch |
Tis Nissin, so M10 x 1.25, like this: http://cgi.ebay.co.uk/Goodridge-BANJO-B ... 286.c0.m14 |
|
| Author: | Johnny Ableto [ 31 Aug 2009 11:12 ] |
| Post subject: | Re: X1 rear MC banjo brake switch |
Thanks for that Pash. |
|
| Author: | pash [ 31 Aug 2009 13:01 ] |
| Post subject: | Re: X1 rear MC banjo brake switch |
You might also consider Buel part H0203.02A8, which is cadmium (or nickel) plated, rather than stainless, is cheaper and more importantly has a rather fetching rubber boot where the wires exit the switch... |
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|