| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| Question for Maz https://www.ukbeg.com/forum/viewtopic.php?f=8&t=22749 |
Page 1 of 3 |
| Author: | chrisx1 [ 29 Oct 2017 16:06 ] |
| Post subject: | Question for Maz |
Do you know which make of Fuel injectors Buell used. I saw a post on I think the X1 Files that said they were produced by Ford. Would you know part numbers by any chance? Also I would like to replace the Lambda sensor O2. Do you know a manufacturer and part number for a replacement. Thanks in anticipation. 
|
|
| Author: | pash [ 29 Oct 2017 16:18 ] |
| Post subject: | Re: Question for Maz |
Can I answer? |
|
| Author: | chrisx1 [ 29 Oct 2017 16:27 ] |
| Post subject: | Re: Question for Maz |
Of course you can Pash. |
|
| Author: | pash [ 29 Oct 2017 16:39 ] |
| Post subject: | Re: Question for Maz |
Lambda sensor is a Bosch 12014 viewtopic.php?p=211576#p211576 But I think yours is OK. You can read the injector manufacturer off the injectors I sent you away with. I think they are Sagem. Used on some Peugeots I believe. The X1 injectors are the same as the 02/03 XB9 injectors. I tried to get them matched up by an injector specialist and this is what he had to say: Quote: those injectors are made by Sagem, nasty little disc injectors, there is no flow rate for those available and when you check on the net you get varying 120 -295cc figures. they are fitted to Puegeot Citroen same injector, they have a horrible habit of partially burning on the solonoids which causes them to stop working at various ecu driving loads. If you want an up grade thats ok we can do this, but I would need you to send me your injectors, I can do a flow analysis and then work out your % increase, but they would have to be mapped in as with any increase flowing injectors they would not be plug and play. There is a Bosch that fits the X1 manifold (but not the XB9), Mickrick is using them in his. Bosch part number is 0280156065. I before buying, I suggest you strip the fuel system down to the injectors to make sure they are not full of crap and try my injectors. |
|
| Author: | chrisx1 [ 29 Oct 2017 17:07 ] |
| Post subject: | Re: Question for Maz |
Thanks Nick. I will do I just want to get some backup bits and pieces which seems to be the sensible thing to do. |
|
| Author: | Maz [ 29 Oct 2017 17:28 ] |
| Post subject: | Re: Question for Maz |
I'm redundant......again 
|
|
| Author: | pash [ 29 Oct 2017 17:42 ] |
| Post subject: | Re: Question for Maz |
Maz wrote: I'm redundant......again Save yourself for the hard questions 
|
|
| Author: | Adam [ 30 Oct 2017 21:32 ] |
| Post subject: | Re: Question for Maz |
I did some cross referencing for Lambdas too. I'll try and dig out the part number and make of the one I fitted. |
|
| Author: | pash [ 14 Nov 2017 19:58 ] | ||||
| Post subject: | Re: Question for Maz | ||||
What's afoot at the Emporium? Could it be a wee test? Wee being Scottish for 'small' rather than with urine...
|
|||||
| Author: | Nutah [ 14 Nov 2017 20:30 ] |
| Post subject: | Re: Question for Maz |
 are they original V aftermarket or is this the original two comparison oh & that vice needs painting 
|
|
| Author: | Maz [ 15 Nov 2017 15:15 ] |
| Post subject: | Re: Question for Maz |
Bosch on the left, OEM Sagem on the right. |
|
| Author: | Nutah [ 15 Nov 2017 15:35 ] |
| Post subject: | Re: Question for Maz |
  large difference between them 
|
|
| Author: | Maz [ 15 Nov 2017 15:53 ] |
| Post subject: | Re: Question for Maz |
Both injectors wide open at 50psi for 60 seconds. Need to try the Bosch injectors in a bike and see what happens to AFV. |
|
| Author: | x1glider [ 15 Nov 2017 18:22 ] |
| Post subject: | Re: Question for Maz |
I'll wait on the results for a bit as I have plenty else to do. If the Bosch don't work out, I'll be hitting up someone here to send some Sagems over to me. I can't get them stateside as none of the major online auto suppliers here carry parts for Citroen/Peugeot/Renault. |
|
| Author: | pash [ 15 Nov 2017 19:32 ] |
| Post subject: | Re: Question for Maz |
x1glider wrote: I'll wait on the results for a bit as I have plenty else to do. If the Bosch don't work out, I'll be hitting up someone here to send some Sagems over to me. I can't get them stateside as none of the major online auto suppliers here carry parts for Citroen/Peugeot/Renault. Mickrick is using Bosch injectors in his X1, the very same part number that Maz has tested above. But if you were to buy Sagems, what would you buy? If you want to find a car that uses them, as a guide you are looking for a 160hp 4 cylinder French model (and knowing nothing about cars I don't know what the model would be). Alternatively, if you really wanted Sagems, you could just buy them from HD... |
|
| Page 1 of 3 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|