Hi all,
I'm trying to remove the rear wheel (having read the 'how to' section) of my XB9SXin order to replace the bearings, but as i turn the axle, the swinging arm starts to splay apart. Is this normal, or should i be concerned? I'd hate to damage the swinging arm. any ideas?
thanks in advance,
Dan

have a read of this thread in the how to

viewtopic.php?f=17&t=1329

if the swingarm is forced apart too much you can damage it. try clamping the swingarm together with tie down straps or something

_________________
My Smugmug Photos

Axle is seized in the bearings, if you force things the weld to the oil tank will fracture.

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

so should he drain the tank first, or put some sand down?

_________________
xxxx

ratchet strap the swing arm as a brace and be very careful.

_________________
I intend to live forever.....................................so far, so good!