initially think there were problems but now overcome , but get maz,s advice on that
| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| Cam cover https://www.ukbeg.com/forum/viewtopic.php?f=8&t=19489 |
Page 1 of 1 |
| Author: | davelong [ 15 Oct 2014 10:45 ] |
| Post subject: | Cam cover |
I was just wondering can the cam cover be powdercoated or does the heat cause the brass/copper things to fall out? Have my cover cut down , just wondering will i polish or powdercoat. |
|
| Author: | pash [ 15 Oct 2014 11:24 ] |
| Post subject: | Re: Cam cover |
I think sillyb has had his whole engine powdercoated... |
|
| Author: | davelong [ 15 Oct 2014 11:27 ] |
| Post subject: | Re: Cam cover |
I was looking at that after doing a search , sillyb had the skills of Maz to fix any problems that arose tho , don't really wanna take a chance on it. |
|
| Author: | coco [ 15 Oct 2014 19:11 ] |
| Post subject: | Re: Cam cover |
initially think there were problems but now overcome , but get maz,s advice on that
|
|
| Author: | gibbsy [ 15 Oct 2014 19:58 ] |
| Post subject: | Re: Cam cover |
Myne is powder coated gloss black with no problems 
|
|
| Author: | brother in buells [ 16 Oct 2014 18:41 ] | ||
| Post subject: | Re: Cam cover | ||
I had the one from my xb done ,and there was nothing wrong with it afther the coating. Only extra i did was bolted it to a piece of plywood and also made a wooden plug for the ignition hole before blasting to keep all the grud out of the bushings and oil passages.
|
|||
| Author: | Adam [ 16 Oct 2014 20:29 ] |
| Post subject: | Re: Cam cover |
Soda blast  Stick it under a tap - job done
|
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|