UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
98 s3 cant get to idle when warm https://www.ukbeg.com/forum/viewtopic.php?f=8&t=15590 |
Page 1 of 1 |
Author: | julek780 [ 30 Sep 2012 13:06 ] |
Post subject: | 98 s3 cant get to idle when warm |
Hi guys my s3 just refuses to idle when warm, will idle when cold on the choke, but then choke pushed fully in just dies . I had adjusted the external idle under the tank, however even fully turned clockwise the bike refuses to idle. When warm bike will rev, any ideas, i have taken carb off and stripped top and bottom, however can not find any thing wrong, no split rubber, or dirt in float bowl. Julian |
Author: | pash [ 30 Sep 2012 14:43 ] |
Post subject: | Re: 98 s3 cant get to idle when warm |
Did you spray WD40 to check the intake seals? Did it sell? |
Author: | julek780 [ 30 Sep 2012 16:24 ] |
Post subject: | Re: 98 s3 cant get to idle when warm |
Thanks have sorted it, recleaned card and found one of the jets blocked. |
Author: | pash [ 30 Sep 2012 16:39 ] |
Post subject: | Re: 98 s3 cant get to idle when warm |
Phew! |
Author: | Bonzo [ 30 Sep 2012 16:50 ] |
Post subject: | Re: 98 s3 cant get to idle when warm |
julek780 wrote: Thanks have sorted it, recleaned card and found one of the jets blocked. Just a stab in the dark here, but was it perchance the idle jet ![]() ![]() |
Author: | Maz [ 30 Sep 2012 16:51 ] |
Post subject: | Re: 98 s3 cant get to idle when warm |
See this quite a lot these days......idle jet/progression drillings blocked on bikes that've been stood a while ![]() |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |