No
| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| XB12SCG 2007 Rear Brake Switch https://www.ukbeg.com/forum/viewtopic.php?f=8&t=15127 |
Page 1 of 1 |
| Author: | PeteJ [ 29 Jul 2012 07:08 ] |
| Post subject: | XB12SCG 2007 Rear Brake Switch |
Looks as if the rear brake switch on the bike is faulty. Can I remove the switch from the top of the rear master cylinder without loosing any brake fluid please. Thanks. |
|
| Author: | pash [ 29 Jul 2012 12:55 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
No
|
|
| Author: | PeteJ [ 29 Jul 2012 13:10 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
Thanks Pash. Looks like I therefore need to get the bike over to Tubs at Moorespeed to get it sorted. Anybody got a rear brake sensors switch to sell please? Or am I on my way to the stealership 
|
|
| Author: | pash [ 29 Jul 2012 17:34 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
A goodridge one will fit, you will need an M10x1.25 thread.  you can get a stainless one they are cheaper than HD they don't come with the correct connector you can cut the old connector off with some tails and solder them to the new switch or buy a connector (I posted about aftermarket matching connectors a while back)
|
|
| Author: | TOPGUMM [ 29 Jul 2012 19:47 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
viewtopic.php?f=15&t=14948&p=202154#p202154 |
|
| Author: | PeteJ [ 30 Jul 2012 09:02 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
Thanks again Pash and to you too Topgumm. I'll give Tubs a chance to settle in to his new job then give him a shout. |
|
| Author: | PeteJ [ 12 Aug 2012 19:25 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
Changed out the banjo switch and remembered to get the two crush washers too. I now know how to bleed brakes. And my rear brake light now works. |
|
| Author: | Bonzo [ 12 Aug 2012 19:56 ] |
| Post subject: | Re: XB12SCG 2007 Rear Brake Switch |
PeteJ wrote: Changed out the banjo switch and remembered to get the two crush washers too. I now know how to bleed brakes. And my rear brake light now works. I did all that, but the brake light still didn't work. Found out afterwards it was a dodgy connector under the seat 
|
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|