Thinking about buying a Metmachex swinging arm for my X1 today but the pictures they have sent me are of a S1, they say this can be fitted to the X1! Are they correct and if they are is it just a matter of an easy change over.

_________________
No 1: X1 Lightning.2000. Fully Mazed
No 2: KTM 1290R Superduke SE

The world maybe round but you can still find the Edge.

Yes, it will fit but why would you want to ?.......standard cast arc swinger is far superior and will polish up just as well

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

Hideous feckin thing, badly constructed and prone to breaking, save yer wedge.

_________________
Life is short - drink the good wine first

I do like the look of them and iv'e not seen one polished to the same standard but thanks for the advice.
Prone to breaking! is that through your own experience?

_________________
No 1: X1 Lightning.2000. Fully Mazed
No 2: KTM 1290R Superduke SE

The world maybe round but you can still find the Edge.

Yes, Black Flagged at Snetterton due to a failed weld, the "brace" (it isn't) ended up scraping on the Tarmac. PoS

_________________
Life is short - drink the good wine first

Thanks for that OF an Maz good to get some positive feedback now looking for a swinging arm to polish up. Know of any?

_________________
No 1: X1 Lightning.2000. Fully Mazed
No 2: KTM 1290R Superduke SE

The world maybe round but you can still find the Edge.

Know? no I don't..... sure that a cast arc will show up on ebay or on here sooner or later...

_________________
Life is short - drink the good wine first

Don't buy the braced version as you won't fit the exhaust back on unless you chop it by about 3 inches,and that's the race can
Apparently metmachex said it would fit with no mods to anything

_________________
Should Have Stuck To making Tubers