look at were you wiggled it
as i would suspect a broken cable at that location
| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| X1 Indicator problem..... https://www.ukbeg.com/forum/viewtopic.php?f=8&t=12467 |
Page 1 of 1 |
| Author: | Babybadger [ 03 Oct 2011 17:25 ] |
| Post subject: | X1 Indicator problem..... |
Had a problem with the indicators the other week. I was resetting the TPS , no drama there, and when I was watching it fire up to temp, I thought check all lights and bulbs are working. The Indicators wouldn't turn on, I did notice the voltage dropped from 13ish Volts down to 12.5-12.8Volts, and with a wiggle of the joints under the seat , they started slowly, the relay clicked, and then afterwards they were fine. As I finished up the TPS reset and made sure it was ticking over ok, i checked again and nothing, wiggle again and they started up..... I did change out the indicators after one got snapped in shipping, but they were fine up until recently? Any ideas anyone? |
|
| Author: | Nutah [ 03 Oct 2011 19:12 ] |
| Post subject: | Re: X1 Indicator problem..... |
look at were you wiggled it as i would suspect a broken cable at that location |
|
| Author: | Babybadger [ 04 Oct 2011 15:34 ] |
| Post subject: | Re: X1 Indicator problem..... |
Ok, so is that a positive feed cable and the frame/seat unit is the earth? |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|