Fitted it last night and it's now spinning over like it should again
So hopefully I might be out next weekend fingers crossed 🤞🏻
P.s forgot to mention I had a go at cleaning the terminals first and it sort of tried but still no good
Starter issues
-
gusm2
- Posts: 2349
- Joined: Wed May 06, 2009 5:10 pm
- Current ride: 99 Cyclone M2
- Location: Liverpool
Starter issues
As I mentioned in an earlier post I've been fettling the bike in readiness for the start of the race season, then just last weekend when I tried to start it I was only getting the dreaded clicking from the solenoid a bit of digging into it and I discovered the terminals inside were completely goosed. A quick browse on eBay and I found a repair kit for less than twenty quid and delivered a couple of days later.
Fitted it last night and it's now spinning over like it should again
So hopefully I might be out next weekend fingers crossed 🤞🏻
P.s forgot to mention I had a go at cleaning the terminals first and it sort of tried but still no good
Fitted it last night and it's now spinning over like it should again
So hopefully I might be out next weekend fingers crossed 🤞🏻
P.s forgot to mention I had a go at cleaning the terminals first and it sort of tried but still no good
You do not have the required permissions to view the files attached to this post.
Last year I joined a group for anti-social people
We haven't met yet.
We haven't met yet.
-
Nutah
- Posts: 10642
- Joined: Tue May 05, 2009 8:00 pm
- Current ride: X1 2001
- Location: southampton
-
Jazzbutcher
- Posts: 1634
- Joined: Wed Aug 01, 2018 7:58 pm
- Current ride: Buell 1125R
Re: Starter issues
Thanks Gordon, I've just changed the starter on mine for similar reasons. Probably pretty similar mech I'm guessing, so a good starting point for me to look at. Thanks again.
Good lick if you get some runs in.
Paul.
Good lick if you get some runs in.
Paul.
Ride Safe & Stay between the hedgerows.
Who is online
Users browsing this forum: CommonCrawl [Bot] and 3 guests
