Hi guys,

I set out to check my timing today & while removing the rear plug, I managed to snap the lead out of the crimp at the plug end.

My local HD dealer in Walthamstow are useless and do not stock these so my question is.....

Can I make up a new plug lead if I get the bits from say Halfords, or do I need to purchase the stock item which will mean waiting weeks for it? Oh, and they are £10 each from the ripoff HD wasters

Urgent advice would be appreciated.

Phil.

In stock for Tuesday delivery.

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

can you prise open the crimp, trim back the lead and recrimp, or isn't there enough free lead?

ah well, worth a try!...

Here in stock for Tue delivery?

PM me at padavis62@aol.co.uk

No......you PM me a delivery address and you'll have it Tuesday

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

PM sent Maz.

Cheers

I know them so well . I went there for some leads the other week to be told the same thing. Turns out I do not need them so saved myself £20 and lost them a sale

Another thing, the plugs were not tightly fitted. The bike was only serviced (10k) a month ago. Should I have a pop at the mech or is this a Buell thing?

Useless isn't the word for them.

They are thick to I noticed. I've only had my Buell for a couple of months and I think I have more knowledge than them.

You must be local to me so give me a call if I can help with anything. TFD.

I'm in Waltham Cross, Herts.

Where are you based?

About 3 miles from HD Chingford (Wathamstow).

Not far then.

I'll keep you in mind if I get stuck.

Thanks

Internet dating works