Thanks pash
| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| Belt tensioner bearings https://www.ukbeg.com/forum/viewtopic.php?f=7&t=1345 |
Page 1 of 1 |
| Author: | DarkHorse [ 30 Jun 2009 14:21 ] |
| Post subject: | Belt tensioner bearings |
Can someone please tell me how to check if my belt tensioner needs new bearings? There is very slight sideways play, only about 1mm, and a slight 'click' feeling when the wheel is spun round. |
|
| Author: | pash [ 30 Jun 2009 15:01 ] |
| Post subject: | Re: Belt tensioner bearings |
I would say change them if there is any play, after all, it is down hill from here... Check the How To section for how to do it... |
|
| Author: | DarkHorse [ 30 Jun 2009 17:08 ] |
| Post subject: | Re: Belt tensioner bearings |
Thanks pash
|
|
| Author: | Dave from Scotland [ 30 Jun 2009 23:42 ] |
| Post subject: | Re: Belt tensioner bearings |
Pash, I didn't want to post this in the "how to" section, as we need to keep that reserved for proper "how to" issues. I should, however, let you know that I have a very early 02 plate XB9R (registered 10/07/02) with twin 6203 bearings in the tensioner wheel. Don't take my word for it, Tubbs removed them and will confirm this (when he's recovered!). Not all of the early "9s" had a single bearing (unless the Buell fairies have been tinkering with my bike whilst I was asleep). Dave |
|
| Author: | pash [ 01 Jul 2009 06:27 ] |
| Post subject: | Re: Belt tensioner bearings |
Hi DFS, thanks for this. I have never seen a tensioner wheel with one bearing in it as I have only pressed out those in my own. I will think of some good words for the How To... |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|