| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| Handle bars https://www.ukbeg.com/forum/viewtopic.php?f=7&t=129 |
Page 1 of 1 |
| Author: | catmeat [ 07 May 2009 19:31 ] |
| Post subject: | Handle bars |
Bought a new set for my xb12s, just wanna no best way to remove throttle, cables, bar ends etc?? |
|
| Author: | catmeat [ 08 May 2009 19:10 ] |
| Post subject: | Re: Handle bars |
What nobody knows?? |
|
| Author: | Polecat [ 09 May 2009 06:38 ] |
| Post subject: | Re: Handle bars |
Just fitted bar risers on mine and had them  ed. Glad I did in the end. If your new bars are a much higher profile than the those fitted there's no spare in any of the cables and brake line. Had to have the whole front end off and re-route everything 
|
|
| Author: | Robs [ 09 May 2009 17:48 ] |
| Post subject: | Re: Handle bars |
catmeat wrote: Bought a new set for my xb12s, just wanna no best way to remove throttle, cables, bar ends etc?? Changed the bars on my xb9s a couple of years back, oem ones for rizoma slightly lower and not so wide, didn't have to change cables or brake line. 60min job. |
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|