Does anyone (Pash ) know the proper name for these bolts and where to obtain them ?

_________________
It's never too late to have a happy childhood.

I made my own for the 1125 1125 are metric and XB are unc

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

Seat quick releases? Do TM sell them?

I thought about making some but struggled to understand what I needed to access under the seat that I couldn't wait the two minutes it takes to remove the screws .

http://www.badweatherbikers.com/buell/m ... 1235431425

http://badweatherbikers.com/buell/messa ... 1078964118

http://www.buellxb.com/forum/showthread ... elease-Mod

_________________
08 Specialized Langster

Thanks Kev & Pash, when at Twin's I'll ask, don't like
going through their site.

My charging connector for the battery is under the saddle
but will change that to the rear compartment.

_________________
It's never too late to have a happy childhood.

I was considering a simpler design (when I should have been working). When do you need them dearest Walt?

_________________
08 Specialized Langster

Interested if you are making some Pash as I always though the bolt location was a bit rubbish

I'll scheme something up

_________________
08 Specialized Langster

Glad it's not just me. I wanted to buy some stuff for a bike once and couldn't get on with their site at all. Went elsewhere in the end. Others have told me the same. I don't know if it's still the same, but I've not tried since.

_________________
If your dreams don't scare you, they are not big enough.

I struggle with it. The search comes up with thousands of stuff, despite what you put in the search box it seems to show you their whole catalogue.

_________________
08 Specialized Langster

I'll pick them up this weekend, if thats ok ?
or any other time is fine Pash.

About Twin; it's a 40 min. drive for me, I just visit them and ask Budje my silly questions.
Help offered if anyone needs some.

_________________
It's never too late to have a happy childhood.

made mine, pushed out the steel insert from the seat, drilled a hole through the head of a bolt, fitted a R clip, and the spaced the bolt from the frame to get the correct height. then stood back and just stared at my Buell for about an hour.

Proper solution but I hope Pash will come up with something

_________________
It's never too late to have a happy childhood.

Was just looking for same, or some other solution! Would be interested if you were making up some too pash