| UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
| Tuber sidestand required https://www.ukbeg.com/forum/viewtopic.php?f=11&t=22015 |
Page 1 of 1 |
| Author: | gusm2 [ 01 Dec 2016 21:19 ] |
| Post subject: | Tuber sidestand required |
Hi folks, I'm wondering if anyone has a spare sidestand that would fit an M2, not sure which years are interchangeable mind's a 99, anything appreciated I'm going to cut it up anyway. |
|
| Author: | brother in buells [ 01 Dec 2016 21:36 ] |
| Post subject: | Re: Tuber sidestand required |
http://www.marktplaats.nl/a/motoren/ond ... ichSnippet It's not mine ,but saw this on a dutch market place! |
|
| Author: | brother in buells [ 01 Dec 2016 21:38 ] |
| Post subject: | Re: Tuber sidestand required |
btw ,don't know how good you are with iron and welding!? but it doesn't look to hard to make a replica |
|
| Author: | gusm2 [ 02 Dec 2016 10:07 ] |
| Post subject: | Re: Tuber sidestand required |
brother in buells wrote: btw ,don't know how good you are with iron and welding!? but it doesn't look to hard to make a replica Thanks for the link but it's a wee bit pricey for what I'm going to do with it, I'll probably have a go at making one 
|
|
| Author: | 03 [ 02 Dec 2016 10:18 ] |
| Post subject: | Re: Tuber sidestand required |
I seem to recall that sometime ago, the central warehouse in Belgium destroyed remaining stocks of side stands as they were slow moving stock. |
|
| Author: | Adam [ 02 Dec 2016 10:28 ] |
| Post subject: | Re: Tuber sidestand required |
I think some people have adapted FireBlade stands to fit?. I've seen another bolted to the primary case, which didn't strike me as a good idea. |
|
| Author: | rik [ 02 Dec 2016 12:20 ] |
| Post subject: | Re: Tuber sidestand required |
03 wrote: I seem to recall that sometime ago, the central warehouse in Belgium destroyed remaining stocks of side stands as they were slow moving stock. The early XB ones did a passable job of destroying themselves (c/w bar end, clutch lever.....) 
|
|
| Author: | gusm2 [ 03 Dec 2016 18:47 ] |
| Post subject: | Re: Tuber sidestand required |
Sorted now. |
|
| Page 1 of 1 | All times are UTC+01:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|