I have snapped the swingarm pivot bolt on my Firebolt today while replacing the bearings. Does anyone have one I can buy please.

What about this one?

http://www.ebay.co.uk/itm/NEW-Genuine-B ... 35c030dc37

_________________
08 Specialized Langster

OK, I have to know......how the fuck did you manage to snap a swingrm pivot

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

_________________
08 Specialized Langster

Yeah, I saw that already Pash but my question still stands

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

I must admit, I was curious also.

Too much spinach in his diet

_________________
Partial to a bit of both

or wrong tools
http://youtu.be/C7Q6eB2Zq50

_________________
Buell Ulysses XB12X 06/08

Thanks for the replies.
Maz, I know I should have gone indoors,switched on the computer, loaded the manual, checked the torque setting and done the job properly. However, the sun was shining and I thought if I get this done quick i can go out for a ride. When it felt tight enough I thought I'll just give it one more pull and that's when the socket spun round with very little effort at all.
I am neither very big or very strong and was not using anything to extend the length of the ratchet and so was pretty surprised when I heard it break.
I did check on here to see if it was a common problem but it appears not.