Hi guys.

I did a little bit of damage to my 2000 X1 exhaust headers during a low speed off a few months ago and the cost of repairs would seem to outway the likely cost of a second hand replacement part.

Anyhow, does anyone have a set of suitable original UK spec X1 headers without any damage and which are surplus to their requirements? If so, please get in touch.

Thanks,

Richard

if you want new ones Al makes em
...memberlist.php?mode=viewprofile&u=3654

_________________
Feros Ferio

fair comment , can you get your marks polished out then re-cam coated ?

_________________
Feros Ferio

If only it was that simple. I have a bit of a flat and some scuffing on one part of the front cylinder header pipe along with some minor scuffing further down on both pipes.

Richard

Time for some fibreglass wrap?
If done carefully and sealed with silicone spray it looks the dogs danglies

_________________
Nige...1125d 9.43@140mph

hi
I have know people make blanks for the ends of pipe then fill with compresed air 20 to 40 psi??
then use welding tourch to heat up dents to cherry red ish and internal pressure blows out dent
normally done on two stroke expansion pipes to good effect

_________________
Buell Ulysses XB12X 06/08

Thanks Nige and Barney.

I'm pretty much resigned to putting up with the cosmetic damage to my ceramic coated headers and am going to start a new thread in the techical forums on some other matters.

Richard