Ok, first up, here's the seat...


As I said it's been re-upholstered by Viking Vinyl, given a new cover and had a thick layer of memory foam over the whole seat.
Next, the seat rails from an S but will fit the SX also..

Finally the undertray - you can se in the second pic where it's been modded for my Uly - point (a) was hightened slightly, point (b) was a cutout to stop it rubbing against the Uly's shock when under full compression and point (c) are 2 small holes where I mounted the bank angle sensor. None are noticeable when the undertray is fitted. I also have the metal battery pan too.


Finally here's just a reference pic so you can see what the subframe/seat looked like fitted (to my Uly)

_________________
"Because it's awesome" is always a good enough excuse
http://www.eugenereisch.com