Nutah wrote:
nice job
maybe..if you don't want to make them ,could you post a drawing
so people could make one for themselves
Thanks again for the positive comment, to be honest I don't have a drawing to post, I had in mind what I wanted to do and I just took a few measurements and set about fabricating the bracket which in the first pic gives a simple enough view on what is required. I used some sheet metal cut from an old boiler flue register plate I had left over, hence the hole in one corner which to be honest I could be bothered to weld up and sand down before spraying with etching primer and satin black paint.
The 2x fixing points are simply some brackets I found lying around cut and formed to suit, not at all difficult assuming you have the necessary tools etc of course.........