Last visit was: Wed Dec 13, 2017 12:16 pm It is currently Wed Dec 13, 2017 12:16 pm

All times are UTC+01:00




 [ 1 post ] 
Author Message
PostPosted: Tue Oct 11, 2016 5:54 am 
Offline

Joined: Thu Jun 23, 2016 9:42 pm
Posts: 22
Current ride: Buell X1
Today I changed rear isolators in my X1. Need to say was easy and quick job.
I'm not a genius so this articles I found very helpful:
http://www.badweatherbikers.com/buell/m ... 1247494017
http://badweatherbikers.com/buell/messa ... 1195065810
First link is instruction how to do it but I need to explain some think: Natexlh1000 said "undo the tiebar heim thing in the left rear." - by this you need to mean engine mount what hold engine to swing arm. Screw you need to find is directly under the battery. After this whole job going smooth. And remember to fix that screw back before you fix 1/2 hex screw on left isolator.
Second link is just what actually you need to buy - part numbers , prices , and chat what is good for you.
I used Hard rubber ones and cheapest. I don't know I did good but I know :old: everything is better if this what was before.


You do not have the required permissions to view the files attached to this post.


Top
   
 
 [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Limited