UK Buell Enthusiasts Group https://www.ukbeg.com/forum/ |
|
Uly XT Oil Pressure Problem!!! https://www.ukbeg.com/forum/viewtopic.php?f=8&t=22002 |
Page 2 of 2 |
Author: | kernow60 [ 06 Jan 2017 21:31 ] |
Post subject: | Re: Uly XT Oil Pressure Problem!!! |
Maz wrote: So, that begs the question of what oil and filter did you use ? Hi Maz Stock Code 62600017 H-D 360 20W50 63806-00Y Oil Filter-Buell Black Oil Filter Obtained from Riders Bristol. Maz probably unlikely, but I'm just wondering if the oil filter itself could be the culprit.??? |
Author: | kernow60 [ 18 Jan 2017 21:37 ] |
Post subject: | Re: Uly XT Oil Pressure Problem!!! |
O.K. it's been a few days since I was able to get back to this problem, but managed to have another look at it today. First off I removed the oil filter and the filter adaptor to inspect the oil filter check valve, guess what no check valve??? So ![]() Next I removed the pressure relief valve again to give it another look see, and on examining it closely I notice a small rub mark on the side of the tapered slide, hardly noticeable but it was definitely there, so I dressed it with some very fine wet & dry until it had almost disappeared. I them found a close fit drill bit, taped the end with a round of masking tape to make the drill a snug fit in the slide, ran the drill at high speed whilst polishing the slide with some solvol-autosol looked pretty good so re-assembled. Fired her up and after the oil light went out left it tickover for several minutes or until it was pretty much up to normal operating temperature and the oil light didn't come on once in that time, so keeping my fingers crossed that I have cured it ![]() ![]() By the way I used a K&N oil filter the second time around. ![]() |
Page 2 of 2 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |