Hmmm......that's strange which manual do you have ?....just checked through all mine and the only figures I can find are for pre-recall mounts which were 73-78ftlbs (98.9-105.7 Nm) and later mounts which are 60ftlbs (81Nm).......the only other figure is for the ''front isolator bolt'' which is 100-110ftlbs (136-149Nm)......are you sure you haven't confused this with the entry for ''Front isolator to cylinder head bolts''

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR

It's a Buell WSM for 1999/2000 Cyclone M2.
Beginning to dawn on me now....it has two listings for isolator bolts:

Front isolator bolt....100 Ibft
Side isolator bolts....100 Ibft

The side ones refered to must be the ones at the back.........

Those figures are for the bolts that pass through the rubber isolators, if you look at the manual again, there is a torque figure for isolator to cylinder head bolt, which in your manual will be the pre recall figure of 73-78 ftlbs.
The recall isolator mount fitted to your bike uses thicker washers under the bolts and a revised torque of 60 ftlbs was introduced for these......you only have to ask

_________________
Mithered ta death.
92 MB
96 S2T
98 S1W
00 M2
01 X1
03 P3
10 CR