Last visit was: Tue Dec 12, 2017 3:40 pm It is currently Tue Dec 12, 2017 3:40 pm

All times are UTC+01:00




 [ 32 posts ]  Go to page Previous 1 2 3
Author Message
PostPosted: Sun Aug 28, 2016 9:13 am 
Offline
User avatar

Joined: Tue May 05, 2009 8:00 pm
Posts: 8150
Current ride: Buell X1 2001
Location: southampton
nice job :idea:
maybe..if you don't want to make them ,could you post a drawing
so people could make one for themselves

_________________
Obey the principles without being bound by them.
Bruce Lee


Top
   
 
PostPosted: Sun Aug 28, 2016 3:31 pm 
Offline

Joined: Mon Jul 07, 2014 2:59 pm
Posts: 81
Current ride: 2010 Ulysses XT
Location: Cornwall UK
Nutah wrote:
nice job :idea:
maybe..if you don't want to make them ,could you post a drawing
so people could make one for themselves


Thanks again for the positive comment, to be honest I don't have a drawing to post, I had in mind what I wanted to do and I just took a few measurements and set about fabricating the bracket which in the first pic gives a simple enough view on what is required. I used some sheet metal cut from an old boiler flue register plate I had left over, hence the hole in one corner which to be honest I could be bothered to weld up and sand down before spraying with etching primer and satin black paint.
The 2x fixing points are simply some brackets I found lying around cut and formed to suit, not at all difficult assuming you have the necessary tools etc of course.........:yup:


Top
   
 
 [ 32 posts ]  Go to page Previous 1 2 3

All times are UTC+01:00


Who is online

Users browsing this forum: CommonCrawl [Bot] and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Limited