..... I'll recheck them but they all appeared to be located securely ....any ideas are always welcome
I've ordered a socket and some pins to make up a lead to wire the CPS direct to the ecu connector which will count out any broken loom wires or bad connections on the 5v where they join inside the loom.

Luckily the test route I use is made up of fantastic biking roads with little traffic on any of it so going out to try it isn't really an hardship
Would be nice to have it sorted to go to BDay though .....prefer to take the X1 because it is far more Buell than the CR

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

_________________
Feros Ferio

Well I've been waiting over a week for my connectors to arrive to make up a slave CPS lead to count out a loom fault ............ I've fitted a 3 pin deutsh connector to match up with the Sensor one and spliced into the sensor 5volt and sensor ground near to the ECM (soldered splices) and removed the sensor signal wire from the ECM connector and fitted the new loom direct into it. Just need to find time to go for a 100mile test ride now ........... hopefully Fri so will log the trip again and see what fault the trace shows IF the problem still exists.
I have taped up the original sensor signal wire

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

Fingers crossed for Muffin

_________________
08 Specialized Langster

or i get him for spares

_________________
Feros Ferio

Kev, are those lucars connectors?!
Spawn of the Devil! Shame on you!

Good luck, by the way

_________________
http://www.youtube.com/watch?v=Pbi5Ggmk ... re=related

yep they are ...tis only a temp job though ....if it does cure the fault I'll either strip the loom to find the fault OR look at making a permanent job of the splices

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

....and


so hows it going Kev

_________________
Feros Ferio

Cans still in bits awaiting the F##king Acoustifil ...... I was working Saturday and out with Harry yesterday and it's pissing down here today as well ......may see if I can borrow some packing from Smarty later today when he gets home then at least i can try it tomorrow evening if the weathers ok.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

Is Muffin cured then?

_________________
08 Specialized Langster

96 trouble free miles tonight ...............obviously I'll have to do that more than once before I get too excited

_________________
2001 X1 2009 1125CR 2006 Uly X3 2010 Uly a fully Maz'd S1 and a 1991 RS1200 Westwind.

Excellent. Shows the power of the ECMSpy logging facility and a bit of trouble shooting...

I am well pleased for you...

_________________
08 Specialized Langster

_________________
Feros Ferio

...........You'll be riding a decent bike to Lauwe then?

_________________
I started out with nothing and still got most of it left.