Last visit was: Wed Jul 17, 2019 4:42 am It is currently Wed Jul 17, 2019 4:42 am

All times are UTC+01:00

 [ 1 post ] 
Author Message
 Post subject: Changing brake pads
PostPosted: Sat Jun 05, 2010 12:27 am 
User avatar

Joined: Fri Feb 05, 2010 9:04 pm
Posts: 16
Location: Kent - The Garden of England
For most people changing a set of brake pads is a piece of cake. The lightning / firebolt setup is a little different to what most people expect, so I put this little youtube video together for the less experienced members. This applies only to the six pot calliper I think the eight port calliper requires a different process. Hope this helps :mrgreen:

stevenorton wrote:
Changing the pads is only half the job. In my experience the caliper's will need cleaning and this is the ideal time to clean them. The main problems with front brakes are caused by corrosion and the buildup of brake dust. Merely changing them is not usually good enough.

greasemonkey wrote:
could do with giving the torque figures for the fasteners JT :idea:

Ash wrote:
Is it wise to put a small smear of coper grease on the back of each pad and on the retaining pin as well ... ?

 [ 1 post ] 

All times are UTC+01:00

Who is online

Users browsing this forum: CommonCrawl [Bot] and 0 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Limited